Pressure Washer 2100 PSI Due 5/8/2024

Pressure Washer Operating Instructions

• Attach a colored tip to the brass tip of the gun wand.

• Turn switch to Off position.

• Plug the pressure washer into an electrical outlet.
  

• Attach garden hose securely in front.

• Turn on garden hose water supply at full strength (with switch still Off).

• Press trigger on pressure washer gun until water flows steadily. This allows air to escape and discharges any residual pressure.

• Turn switch to On position to start the pressure washer.

• Turn switch to Off position when finished.

• Unplug electric cord.

• Turn off water supply.

• Press trigger on pressure washer gun to release water pressure.

Troubleshooting - if the motor pulses and pressure is not consistent, the motor may be wearing out and need a lot of rest. You can try the following procedure to still use the pressure washer successfully. Leave the On/Off switch in the On position as you do these steps:

1. Wait at least 30 seconds to give the motor time to rest.
2. Pull the trigger, and If the motor stays on instead of pulsing, keep pulling the trigger for at least 30 seconds to clear any air out of the system.
3. If the motor still pulses, repeat steps 1 and 2. If it is still pulsing after repeating those steps, continue to the next step.
4. Press and hold the Reset switch on the plug for at least 10 seconds. A red light should come on when you release it (if not, the pressure washer is probably broken).
5. Pull the trigger and if the motor stays on (instead of pulsing), keep pulling the trigger for at least 30 seconds to clear any air out of the pump.
6. If the motor is still pulsing, leave the On/Off switch in the On position, unplug the electric cord, and hold the Reset switch while plugging in the electric cord.